| Specifications : |
Ingersoll-Rand TH60 Drilling Rig for Sale
Used Ingersoll-Rand Drilling Rig for Sale
SOLD
Model : TH60 Drill Rig
Manufacturer : Ingersoll-Rand
Year : 2000
Condition : Used
Description:
2000 Ingersoll-Rand TH60 Drill Rig
IR 825 cfm / 350 psi Air Compressor
Pipe Rack
4 Hydraulic Leveling Jacks
7 rod carousel
CAT 15 GPM Water Injection Pump
Rebuilt - 6,250 / 4,650 ft/lbs of Torque (2 speed 134/180 RPM) AC Spur Power Head
26,500 lbs of Pullback
18,000 lbs main winch & 2,000 lbs sandreel
Mounted on a International 5600i Truck
CAT C-15 Diesel Engine @ 475 HP
10 Speed Transmisson
Miles 56,301
17,400 Frame Hours
Repairs completed in 2015:
Install new rear carrier springs
Clean cab interior
Repair driver seat
Install new batteries, cleaned cables and clamps
Replace engine coolant hose
Replace Power steering hose
Repair drill table
Repair drill table holding fork box
Repair rear driller and helper platforms
Install new feed system wire rope with thimbles and clips .
Install new feed system sheave pins and bushings
Repair lower sheave guards
Repair DHD lubricator with new access door
Repair water injection add new drive coupler guard
Remove rusted tool box (small) under rod box replace with open basket
Repair tower retract linkage
Rebuild carousel speed reducer
Repair air leaks
Replace operator foot pedals , straighten table breakout wrench pivot pin
Repair change over box in cab
Replace rotation pump control cable
Install new RH two speed wiring
Install new council oil pressure gauge
Disassemble compressor air cleaner to clean (filter OK)
Replaced control panel controls weather boots
Replace control panel winch pilot control
Straightened upper breakout wrench and rain cap
Location : USA
|
